Use for T-REX 550E / 600E / 600N
* 3-axis gyroscopic flybarless system to simulate the stability of mechanical flybar system, yet at the same time achieving agile 3D performance.
* Utilizes Silicon Micro Machine (SMM) sensors for excellent stability.
* 12 bit processors providing ultra high resolution, resulting in highly precise controls
* Software upgradable through PC interface adapter (sold separately)
* Simplistic setup process without the need of external devices. Setup is done through 5 steps and 2 sensitivity adjustments. Rudder setup is identical to GP780 gyro, minimizing learning curve.
* Flybarless system dramatically improves 3D power output and efficiency, resulting in reduced fuel or electricity consumption.
* Highly sensitive gyroscopic sensors combined with advanced control detection routine providing higher hovering and aerobatic stability than other flybarless system.
* Suitable for all CCPM and mechanical mixing system.
* Compatible with helicopter of all sizes from T-Rex 250 to T-Rex 700.
* Innovative Pitch Gauge as an aid to facilitate pitch adjustments.
* High frame rate signal output for faster and higher precision servo response.
* Capable to operate between 3V to 8.4V, compatible with high voltage servos.
* Small footprint, light weight, minimalists and reliable design.
Specifications:
* Suitable Voltage Range: DC 3~8.4V
* Current Consumption: DC 11.1-22.2V 3-6cell Li-Po
* Flip and Roll rate detection speed: ±300degrees/sec
* Rudder rate detection speed: ±500degrees/sec
* Sensor resolution: 12bit
* Operating temperature: -20℃~65℃
* Operating humidity: 0%~95%
* RoHS certified
* Dimension:
Control box: 42x26.5x14.5mm
Sensor: 22.3x21.7x14mm
* Weight:
Control box:16g
Sensor:9g
Included in box:
* Main Rotor head Set x1
* Flybarless control unit x1
* Flybarless Sensor x1
* Screw bag x1
* 550EFL Linkage rod A x2
* 550EFL Linkage ball A x2
* D6DF Servo Horn x3
* D6DJ Servo Horn x3
* Head Stopper x1
* Mixing base assembly x1
* Pitch Gauge x1
* Signal extension wire 100mm x1
* Signal extension wire 220mm x1
* Sensor mounting foam x2
